How do you drain all the fluid out of a transmission?

How do you drain all the fluid out of a transmission?

The trick on how to drain transmission fluid is to work from the top, sucking out the old fluid up through the filler tube. Then refill with fresh fluid. A hand-operated vacuum transmission fluid pump makes the job simple and clean. You can remove one-third to one-half of the fluid from the transmission at a time.

How do you drain the transmission fluid from a torque converter?

This is done by putting a big breaker bar and socket or very large box end wrench on the pulley nut located at the front end of the crankshaft. Then remove the drain plug and let the converter drain into a drain pan. When it’s empty, retighten to the torque figure specified in the factory shop manual.

Do you have to drain transmission fluid when removing transmission?

Once the transmission is moved out from underneath the vehicle, pull the torque converter out of the transmission and drain the fluid into a catch pan. Note: The fluid will need to be drained from the converter regardless of whether you plan to reuse it or replace it.

Can you fill transmission through drain plug?

You cannot fill the transmission through the drain hole, but MaxLife ATF is good to go for your automatic transmission.

Can a transmission pan be drained without a drain plug?

Turns a typical transmission pan without a drain plug into a convenient transmission pan with a drain plug After installation, draining the transmission fluid can be accomplished without the mess and hassles of removing the pan Backed by the manufacturer with a 1 year limited warranty To see our price, add these items to your cart.

How do you drain the transmission fluid in a car?

Drain the Transmission Fluid Here comes the most important step, draining the transmission fluid. It is quite simple, and you can do with two methods. Either locate the drain plug and remove it from where you can extract the fluid or take off the whole transmission fluid pan carefully.

How to drain transmission fluid in a B & M?

Draining the transmission fluid can be a hot, messy chore if you have to remove the entire transmission pan just to drain the fluid, but the next time could be the last time — if you add B&M’s universal drain plug. With the pan off the car, simply drill a hole and bolt in the drain plug kit.

What kind of washer to use for transmission drain plug?

Install a copper crush washer on both sides of the pan and use Loctite 592. 24 ft/lbs of torque on the nut and no leaks at all. Working great on my MB GL350 722.9 transmission. The plug part does stick down a lot. Will find a replacement on next fluid change.