Table of Contents
How do I change the clock spring on my airbag?
For most vehicles, the steps to remove the clock spring are as follows:
- Remove Steering Wheel Bolt Cover Clips.
- Remove SRS Airbag Control Module Bolts.
- Remove the SRS Airbag Control Module from the Steering Wheel (make sure you disconnect any electrical connectors)
How much does it cost to replace an airbag clock spring?
The average airbag clock spring replacement cost for most car owners is between $395 and $419, with the labor costs ranging between $91 and $115 and the cost of the parts around $304. Although this price does not include taxes and fees, it does give you an estimate of what you can expect from your local mechanic.
Does a clock spring need to be programmed?
Does a new clock spring need to be programmed? No, the clock spring itself will work without programming. If your clock spring has an integrated steering angle sensor, you may need to carry out a steering angle reset, reset the stability control, and ABS lights.
How long does it take to change clock spring?
This particular part is located between the steering wheel and the steering column. A clock spring is a flat cable that is wound in a spiral shape that looks similar to a clock spring. The average clock spring repair is going to take less than one hour.
What is another name for a clock spring?
Alternative names for the clock springs are clock spring coil, coil assembly, cable reel assembly, coil spring unit and contact reel.
How does an airbag clock spring work on a car?
An airbag clock spring enables the connection of electrical wires from the airbag computer to the driver’s side airbag while the steering wheel is in motion. This clock spring also connects the horn and other switched controls located on the steering wheel such as radio and cruise controls. Symptoms…
How often should I change the clock in my Audi?
If you live in Colorado, re-setting the clock in your Audi is necessary at least a couple of times a year. Always remember to “Spring Ahead” and “Fall Back”. When the time comes to make this change, it might also be a good time to think about preparing your car for the change of seasons.
How do you remove a clock spring from a car?
The clock spring outer plate may need to be rotated slightly to access the screws. These screws are a number 15 Torx head. Using a Torx head screwdriver or socket to remove the mounting screws by turning them counterclockwise. Use caution as not to drop the crews down inside of the steering column.
Where does the clock spring go on a steering wheel?
4. Remove the Clock Spring: The clock spring sits over the center shaft of the steering column and is held in place by a set of small screws or plastic clips. Once the steering wheel has been removed do not rotate the clock spring upper plate.