How many gallons are in a foot of well pipe?

How many gallons are in a foot of well pipe?

A standard 6-inch diameter drilled well can store 1.5 gallons of water per foot. If you know the depth of the well, the level of the water and pump depth, you can figure out the water storage capacity.

How many gallons of water does a well hold?

The typical 6-inch diameter well will hold approximately 1.5 gallons of water per foot of casing. The height of the water above the pump when it is not operating, multiplied by the gallons of water per foot of casing approximates the amount of available storage within the well casing.

How do you calculate volume of pipe in gallons?

Multiply cubic feet by 7.48 to calculate the volume of a pipe in gallons. There are 7.48 gallons of water in one cubic foot. This is a conversion you will use often, so it is best to memorize it. To determine the volume of a pipe in gallons, simply multiply the volume in cubic feet by 7.48. In our previous example,…

How do you calculate water gallons?

Tank Size to Gallons of Water Formula. Determining the amount of water in your aquarium is as simple as knowing that volume equals length times width times height and that 1 cubic inch of water is equivalent to 0.004329 gallons. Therefore, the volume of your tank in gallons of water = length x width x height (measured in inches) x 0.004329.

How many gallons in 2 inch pipe?

2-inch pipe: 850 gallons per minute; 3-inch pipe: 1,900 gallons per minute; 4-inch pipe: 3,400 gallons per minute; To give you an idea of size and scope, a 24-foot above-ground round pool, 5 foot deep, contains roughly 16,000 gallons of water. With a typical two-inch pipe for sprinklers that breaks, you could fill a pool in about 20 minutes. If your standard half-inch pipe breaks on the way to work, nine hours later you can have up to 27,000 gallons pass through your property.

What is the formula for finding the volume of a pipe?

To estimate pipe volume use the following formula: volume = π × radius 2 × length. Find the diameter and length of the pipe in inches or millimeters.